Ubiquiti USG Access Point Firmware 4.3.41.4975503

Changes:

- IPsec components forklift upgraded to latest EdgeRouter 1.9.7. Upgrades strongswan to 5.2.2, and all the relevant configuration and service management pieces to same as EdgeRouter 1.9.7
- Fixes L2TP with PPPoE WANs
- Adds ability to use L2TP and site to site IPsec at the same time
- Fixes various other IPsec edge case bugs - some rekeying problems, among other possibilities.
- Updated to same kernel source as ER 1.9.7
- Security updates for the following: CVE-2016-10229 and CVE-2016-2085 - UBNT backported where Linux and Debian have not (yet at least).

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.