Ubiquiti UAP-AC-Pro Access Point Firmware 3.7.47.6194

Changes:

- [UAPG3] Adaptive noise immunity (ANI) tweaks, which also results in a performance boost.
- [UAP] Disable incomplete 5GHz multicast enhancements, as it was causing multicast traffic to incorrectly be dropped.
- [UAP] A few fixes for minimum rate control.
- [USW] Fix an issue with IGMP snooping in a daisy chain topology.
- [SEC] Important security improvement for all UAP/USW hardware.
 

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.