Ubiquiti UAP-AC-LR Access Point Firmware 3.7.21

New Features:

- [UAPG2] Enable 802.11r support in hostapd.
- [UAPG2] Fix 802.1x Identity, previously did not display.
- [UAPG1] Revert update base driver to 10.2.
- [UAP] Fix memory corruption, which caused a memory leak and possibly other issues.
- [UAP] Fix minor resource leak.
- [UAP] Revert disable CCK rates.
- [UAP] Changes to help with connectivity issue while STA roams.
- [UAP] Further tweaks to rate control logic.
- [UAP] Add support for AC-M/AC-M Pro multi-hop uplink.
- [UAP] Fix known issues with wireless uplink.
- [USW] Fix issue with jumbo frames not passing through LAG groups.

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.