Ubiquiti UAP-AC-LR Access Point Firmware 3.7.55.6308

Changes:

- [UAPG3] Backend change to help with device stability.
- [UAPG3] Enable mininum rate and MAC ACL functions.
- [UAPG2] Re-enable minimum rate and MAC ACL functions.
- [UAPG2] Fix the loss of connecting when using VLAN 2 on AC-IW, UAP-AC-PRO,/EDU UAP-AC-M-PRO.
- [AC-G1] Fix wireless connectivity.
- [UAP] Improve logging when using bandsteering.
- [UAP] Disable IPv6 on VLAN bridge interfaces by default, to prevent multiple interfaces sharing the same IP.
- [USW] Update openssl package to 1.0.2k.
- [USW] Update evostream package to 1.0.12.
- [USW/XG] Add system LED control.
- [SEC] Fix CVE-2016-10229.
 

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.