Ubiquiti U7-Pro Access Point Firmware 7.0.35

Improvements:

- Improved 2.4GHz latency.
- Improved Voice traffic prioritization.

Bug Fixes:

- Fixed incorrect channel width (20MHz) being reported in device table when 6GHz radio is broadcasting at 320MHz.
- Fixed connectivity issues with 802.11ac clients (e.g. Broadcom-based MacBooks) leading to stalled WiFi and unexpected disconnects.
- Fixed missing 6GHz neighbor reports
- Fixed kernel crashes to improve overall stability.
- Fixed channel interference being reported as 100% during DFS CAC.
- Fixed 6GHz channel change causing a full provision (leading to all clients disconnecting) for ~60 seconds.
- Fixed APs going into "Adoption Failed" state in some cases when using a third-party gateway.

Known issues:

- SSIDs using RADIUS assigned VLANs or on different VLANs from the native VLAN may operate at slower than expected speeds. This is our top priority to resolve.

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.