Ubiquiti Power AP N Router Firmware 6.1.8.32774

New:

- New: IPv6 discovery support
- New: Enable IPv6 after Reset to Factory Defaults
- New: UNMS agent upgrade to v0.4.0

Regulatory:

- Add Paraguay country code
- Add Swaziland country code
- Add missing frequencies 5170 MHz and 5175 MHz for HT20 for New Zealand
- Enable UNII-1 and UNII-2A bands for Australia
- Enable UNII-1 indoor bands for Canada
- Enable UNII-2C indoor bands for Kazakhstan
- Extend UNII-3 band up to 5875 MHz for Russia
- Enable indoor channels for Brazil: 5150-5250 MHz, 5250-5350 MHz
- Update channel plan for Bahrain
- Update Lithuania regulatory

Enhancements:

- Improved CCQ calculation and reporting
- airOS stability improvements

Fixes:

- Fix: Sometimes station stops passing traffic
- Fix: M900 issues (possible fix)

WEB UI:

- WEB UI: Fix country code selection issue

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.