Ubiquiti PicoStation M2HP WiFiCloudNet Firmware

Features:

- Powerful Cloud Managed System
- No On-site Wireless LAN Controller required
- Enables Wireless Mesh to Multi Vendor’s Access Point
- Two SSIDs, Public and Private SSID
- Captive Portal with Bandwidth Control System and Voucher
- Custom Splash Page support to Market your own Brands
- Radius Support
- Safe and Secure
- Protect your SSIDs with WPA Keys, AP Isolation and LAN block Feature which prevents user to see each others
- Auto Outage Alerts based on Network
- Real time Network Statistics for individual devices
- Over-the-Air Firmware upgrade
- Custom Script features

 Install WiFiCloudNet Firmware:

 - Power off the PicoStation M2HP
- Windows PC's Ethernet must be configured manually with the following settings
- IP Address: 192.168.1.254, Subnet Mask : 255.255.255.0
- Connect your PicoStationm2hp device to your PC
- Keep holding the reset button, then power the unit on. Wait 8 seconds then release the button. Signal LEDs will be lit indicating that the device is ready to receive the firmware
- Make sure that PicoStation M2HP device responds to pings (perform a ping 192.168.1.20 from a DOS window), if it does not, go back to the first step
- From Windows PC, you can use TFTP command line from a DOS window (START COMMAND PROMPT) and go into the same directory where you stored the firmware. Run following command tftp -i 192.168.1.20 put wcn-v1-picom2hp.bin
- Wait for a while to allow the device to reboot - do not power off the device during the procedure. It will take a DHCP IP address, if a DHCP server is available; otherwise it will take the 192.168.66.1 fallback IP address
- Now your PicoStation M2HP is ready to add in your account with wificloudnet.com

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.