Ubiquiti EdgeRouter ER-6P Router Firmware 1.10.10

Fixes:

- UNMS - Fix bug when the connection with UNMS failed if LLDP was enabled on ER-PoE
- WebGUI - Fix bug when ER could be DDoSed by opening a lot of unauthenticated WebGUI sessions
- WebGUI - Fix WebGUI bug when VLAN configuration tab was missing on EP-R6
- WebGUI - Fix bad title displayed in the browser tab
- OSPF - Fix memory leak in OSPF when access-list is configured to filter received routes
- IPsec - Fix potential authorization bypass vulnerabilities in strongSwan (CVE-2018-16151, CVE-2018-16152, CVE-2018-17540)
- OpenSSL - Fix CVE-2019-1559 security vulnerability in OpenSSL and upgrade OpenSSL to 1.0.1t-1+deb8u11
- Bootloader - Adds the latest bootloader that supports TFTP recovery
- Kernel - Fix SACK vulnerabilities in TCP networking stack (CVE-2019-11477, CVE-2019-11478)
- Kernel - Fix excessive resource consumption flaw in TCP networking stack (CVE-2019-11479)
- Wizard - Fix wrong WAN interface in "Basic Setup Wizard" on ER-X and ER-4
- Wizard - Add IPv6 firewall rules by default in "Basic Setup Wizard"

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.