TP-Link TL-WA901ND V3 Access Point Firmware 141030

450Mbps Wireless N Access Point

- 450Mbps wireless transmission rate, brings smooth wireless N experience
- Supports multiple operating modes: Access Point, Client, Universal/ WDS Repeater, Wireless Bridge
- Easily setup a WPA-PSK/WPA2-PSK encrypted secure connection at a push of the WPS button
- Up to 30 meters (100 feet) of flexible deployment with included Power over Ethernet Injector

Modifications and Bug:

New Features/Enhancement
(1) Added Logout option to logout after configuration .
(2) only allowed one user to login the management webpage at the same time.
(3) Improved the security mechanism, enhanced the ability to prevent the XSS and DoS attack.
(4) Optimized the remote access module, interface display and the performance of Smart IP.
Bug Fixed：
(1) Fixed a bug that the remote access function would not affect till a reboot.
(2) Fixed an issue that some Samsung Smart TV can't get Internet access when connected to TL-WA901ND in Client mode. 
(3) Fixed a bug that the Broadcasting packet can't be transmitted from LAN to WLAN in Multi-SSID mode.
(4) Fixed a bug that the channel display was incorrect in Bridge with AP mode.

About Access Point Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.