NETGEAR WNDAP350 Access Point Firmware 2.1.8

Fixes:

- Fixed the issue that carrier interference not getting detected in 5 GHz.
- Fixed the ping loss issue observed on M3 Mobile PDA.
- Added dynamic VLAN support.
- Added 2.4 GHz carrier sense fix.
- Changed the behavior such that if the serial number of the AP is already registered, do not contact the registration server again on clicking every configuration page.
- Fixed the problem that access to GUI pages is slow when DNS server is not resolved
- Fixed the issue that beacons are not getting updated properly when Rogue AP is enabled. This is causing throughput inconsistencies and packet loss when Rogue AP is enabled.
- Fixed problem that if wrong DNS Server addresses is configured, AP is unable to get response.
- Added IGMP Snooping support.
- Fixed the packet loss issue when Rogue AP detection is enabled.
- Fixed the problem when client connected to each band, but it only shows 2.4GHz band.
- Fixed the security issue where user is able to log-in without username & password.
- Changed to code to support CE Adaptivity.