NETGEAR FVS318N Firewall Firmware 4.3.5-3

Bug Fixes:

- Fixed the device crash issue
- Fixed an issue where the inbound block firewall rule must configure the LAN Server IP address.
- Fixed an issue where the deleted VPN client still can connect a VPN tunnel to the device
- Fixed the issue where the custom ports does not work with QoS rules.

Known Issues and limitations:

- Unable to add IP address or network in by source IP address page.
- Observed inconsistent behavior with voice traffic when server is lying in LAN and DMZ side.
- Device showing blank certificate when subject name is having successive comma.
- For the port speeds 10Base T FULL_Duplex and 100Base T FULL_Duplex, the duplex setting is showing as half.
- [CLI]Able to add 2 mode config records with same pool start IP and end IP.
- Device is accepting same Local and Remote LAN IP in manual tunnel.
- When "Disable Ping Reply on LAN Ports" is enabled the WAN IP of router is not reachable from the LAN host.
- No NAT translation of SIP headers during REGISTER, outbound call and SDP.
- There is no validation for SIIT Address field.
- IPv6 IPSec client tunnel is not getting establish in main mode.
- Device is not accepting the static route for the network 0.0.0.0 on LAN or VLAN interface.
- [IPv6]Unable to run IPERF-UDP and FTP traffic from LAN to WAN on SIIT tunnel.
- Stun packets are getting drop in SIP module.
- Device IPv6 WAN is not getting RADvD IP address when Router's MAC Address is configured for "Use this computer's MAC Address" or "Use this MAC Address".
- [CLI]There are no proper validations for the domain name in CLI.
- [CLI]schedules are not getting edited properly from CLI.
- Able to see wireless logs with "local wireless" tag and with "kernal kernal" tag.
- After Successful connection through WPS PIN method, status message is not correct.

Note:

- Support 50 VoIP phone calls.
- Supported characters: `~!#$&()-+|;:' " < > and space. Restricted these characters in password fields due to security reasons [to avoid the SQL attacks etc.,].

Installation Instructions:

- Download and extract the new firmware to a convenient place such as your desktop.
- Reboot the firewall before beginning the update process.
- Select Administration > Settings Backup and Firmware Upgrade from the main/submenu.
- In the Router Upgrade section, click Browse.
- Locate the downloaded file and click Upload.
- This will start the software upgrade to your VPN firewall. This may take some time. Do not interrupt the upgrade process.
- At the conclusion of the upgrade, your firewall will reboot.

About Gateway Firmware:

By applying this firmware, your gateway can receives fixes for various vulnerability issues, support for newly developed technologies, several authentication-related enhancements, as well as other changes.

However, due to the wide variety of gateway models, as well as the large number of manufacturers, in order to perform a firmware update properly, it would be best if you read and understand the installation steps of this specific model.

In addition to that, it is also recommend that this process be initiated in a steady power environment, and only when you have completely familiarized yourself with the upgrade procedure.

Bear in mind that failing to perform a successful update or interrupting the firmware installation in any way can cause serious malfunctions to the gateway, and might even render it unusable.

Therefore, if you intend to install this version, click the download button and apply it to the gateway. To stay up to date with new releases, all you have to do is check back with our website as often as possible.