MikroTik RouterOS MMIPS Firmware 6.46.2

What's new in 6.46.2

- chr - improved stability when changing ARP modes on e1000 type adapters;
- console - prevent "flash" directory from being removed (introduced in v6.46);
- console - updated copyright notice;
- crs305 - disable optical SFP/SFP+ module Tx power after disabling SFP+ interface;
- defconf - fixed "caps-mode" not initialized properly after resetting;
- defconf - fixed default configuration loading on RBwAPG-60adkit (introduced in v6.46);
- lora - fixed packet sending when using "antenna-gain" higher than 5dB;
- lte - fixed "cell-monitor" on R11e-LTE in 3G mode;
- lte - fixed "earfcn" reporting on R11e-LTE6 in UMTS and GSM modes;
- lte - report only valid info parameters on R11e-LTE6;
- ppp - fixed minor typo in "ppp-client" monitor;
- qsfp - do not report bogus monitoring readouts on modules without DDMI support;
- qsfp - improved module monitoring readouts for DAC and break-out cables;
- routerboard - added "mode-button" support for RBcAP2nD;
- security - fixed vulnerability for routers with default password (limited to Wireless Wire), admin could login on startup with empty password before default configuration script was fully loaded;
- system - fixed ".auto.rsc" file execution (introduced in v6.46);
- system - fixed "check-installation" on PowerPC devices (introduced in v6.46);
- traffic-generator - improved memory handling on CHR;
- webfig - allow skin designing without "ftp" and "sensitive" policies;
- webfig - fixed "skins" saving to "flash" directory if it exists (introduced in v6.46);
- winbox - automatically refresh "Packets" table when new packets are captured by "Tools/Packet Sniffer";
- winbox - fixed "Default Route Distance" default value when creating new LTE APN;
- winbox - removed duplicate "join-eui" and "dev-eui" parameters under "Lora/Traffic";

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.