MikroTik RouterOS SMIPS Firmware 6.48.4

What's new in 6.48.4:

- branding - fixed missing branding skins if "skins" folder does not exist;
- bridge - added MAC and IP source addresses information for DHCP snooping log;
- bridge - fixed "vlan-encap" setting for filter and NAT rules;
- bridge - improved system stability when using IGMP snooping and changing bridge MAC address;
- capsman - use Bits instead of Bytes for "ap-tx-limit" and "client-tx-limit" parameters;
- crs3xx - fixed unknown multicast flood to CPU when IGMP snooping is used;
- crs3xx - improved system stability when increasing interface L2MTU for CRS318 devices;
- defconf - fixed default configuration loading on LHG R;
- defconf - fixed minor typo in configuration description;
- dhcpv6-server - fixed false missing IPv6 Pool warning for dynamic bindings;
- dns - fixed CNAME query when target record is not in cache;
- dns - fixed cache memory leak when resolving CNAME domains;
- health - fixed voltage monitor on BaseBox5 devices;
- health - improved temperature reporting;
- ike2 - added "MS-CHAP-Domain" attribute to RADIUS requests;
- leds - fixed "/system leds" menu on RBLHG-2nD;
- lora - added additional predefined network servers;
- lte - added support for Sharp 809SH;
- routerboard - fixed "reset-button" on hAP ac;
- system - improved stability when receiving bogus packets;
- telnet - fixed "routing-table" parameter usage;
- w60g - improved stability in low temperature environments;
- webfig - do not show "units" twice in multi list entries;
- winbox - added "Cloud Backup" options under "Files" menu;
- winbox - added "interworking-profile" parameter under "Wireless" menu;
- winbox - added support for PTP;
- winbox - do not show "Functionality" field for LTE interface if it is not provided;
- winbox - fixed "Switch" menu on RBwAPG;
- winbox - fixed "vid" parameter under "Bridge/Hosts" menu;
- winbox - show "System/Health" only on boards that have health monitoring;
- wireless - added U-NII-2 support for US and Canada country profiles for hAP ac^3;
- wireless - added U-NII-2 support for US and Canada country profiles for hap ac, hAP ac^3 LTE6, Audience and Audience LTE6;
- wireless - updated "israel" regulatory domain information;

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.