MikroTik RouterOS MMIPS Firmware 6.47 RC 8

Changes in this release:

- console - fixed "clear-history" restoring historic actions after power cycle;
- console - removed "edit" and "set" actions from "System/History" menu;
- crs3xx - fixed "ingress-rate" property on CRS309-1G-8S+, CRS312-4C+8XG, CRS326-24S+2Q+ devices;
- defconf - fixed default configuration loading after fresh install (introduced in v6.46);
- dhcpv6-client - improved error logging when when renewed address differs;
- fetch - fixed "User-Agent" usage if provided by "http-header-field";
- health - fixed health reporting on OmniTIK 5 PoE ac;
- health - improved health reporting on CCR1072-1G-8S+;
- ipsec - improved system stability when processing decrypted packet on unregistred interface;
- l2tp - improved system stability when disconnecting many clients at once;
- lora - improved confirmed downlink forwarding;
- lte - do not reset modem when setting the same SIM slot on LtAP;
- lte - fixed multiple APN reactivation after deactivation by operator;
- lte - show SIM error when no card is present;
- netinstall - removed "Flashfig" from Netinstall;
- netinstall - removed "Make Floppy" from Netinstall;
- netinstall - signed netinstall.exe with Digital Signature;
- ppp - prioritize "remote-ipv6-prefix-pool" from PPP secret over PPP profile;
- snmp - added "dot1qTpFdbTable" OID reporting for Q-BRIDGE-MIB;
- snmp - fixed "dot1dBasePort" index offset for BRIDGE-MIB;
- snmp - fixed health related OID polling (introduced in v6.46);
- snmp - improved stability when polling MAC address related OID;
- supout - fixed autosupout.rif file generation (introduced in v6.46);
- w60g - use "arp" and "mtu" parameters from master interface when creating a new station;
- winbox - added "auto-erase" option to "Tool/SMS" menu;
- winbox - fixed "allowed-number" parameter setting invalid value in "Tool/SMS" menu;
- winbox - show "LCD" menu only on boards that have LCD screen;
- wireless - improved compatibility by adding default installation mode and gain for devices with integrated antennas;
- wireless - improved compatibility for Switzerland wireless country profile to improve compliance with ETSI regulations

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.