MikroTik RouterOS ARM Firmware 6.47.3

What's new in 6.47.3:

- bridge - fixed host table update on SNMP query;
- crs3xx - fixed hardware offloaded bonding on Ethernet interfaces for CRS354 devices;
- crs3xx - fixed hardware offloaded MPLS forwarding when using bonding interfaces;
- crs3xx - fixed switch ACL rules for CRS312, CRS326-24S+2Q+ and CRS354 devices;
- crs3xx - improved Ethernet port group traffic forwarding for CRS354 devices;
- crs3xx - improved system stability when using hardware offloaded MPLS;
- dns - fixed multiple TXT string replies;
- dns - hide default static entry "type" from export;
- dot1x - fixed duplicate EAP request packets for server;
- dot1x - fixed EAP packet version numbering;
- ike2 - fixed local side NAT detection;
- lte - fixed multiple passthrough APN default route installation;
- lte - fixed RSCP value reporting;
- lte - validate interface existence on initiation;
- ospf - fixed disappearing NSSA default route;
- ospf - fixed processing of "unknown" LSA type;
- poe - fixed "power-cycle" functionality on RB960GSP;
- routerboot - fixed etherboot FCS errors with 100Mbps rate for CRS305, CRS309 and CRS317 devices ("/system routerboard upgrade" required);
- webfig - fixed negative value usage in "spoof-gps" parameter (introduced in v6.47.1);
- wireless - allow setting "tx-power" up to 40;
- wireless - fixed potential wireless driver issue related to CVE-2020-3702; 

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.