Ligowave LigoDLB Router Firmware 7.52

Manufacturer:

Description

DOWNLOAD NOW

What’s new in 7.52 firmware release

- LigoDLB (7.52) iPoll 3 is only compatible with LigoDLB series
- LigoDLB (7.52) iPoll 2 is compatible with Deliberant APC (7.02) iPoll 2

NEW:

- Added iPoll v3 protocol
- Added Smart channel width for Station/CPE mode (scans through all channel sizes)
- Added Multicast enhancement option for AP mode
- Added Channel width selection for Site Survey tool
- Added Non-standard channel option for Site survey tool
- Added Ethernet settings option
- Added Traceroute tool
- Added Ping tool
- Added Port forward option for router mode
- Added option to control Static routes for router mode
- Added option to list DHCP server’s leases
- Added RADIUS DAS support for Disconnect-Request, RFC5176
- Added option to hide indoor channels for AP mode
- Added Hungarian language support

Improvements:

- Updated regulatory domains for India, Norway, USA
- Improved Linktest calculations on 11n mode
- Disabled single option for legacy modes a/b/g
- Removed ack timeout from gui
- Improved IGMP snooping when vlans are used
- Added additional options for PPPoE
- Secondary IP is always untagged
- Traffic management works with iPoll 2 only

Fixes:

- Fixed Station connecting issue when small RTS/CTS value is set
- Fixed issue when 11g client was shown as 11b client on the AP

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.

Ligowave LigoDLB Firmware LigoDLB Router Firmware Ligowave LigoDLB Firmware Update LigoDLB Firmware Ligowave Router

  CATEGORY:
Router / Switch / AP
  COMPATIBLE WITH:
OS Independent
  file size:
6.8 MB