Intellinet GuestGate MK II HotSpot Gateway Firmware 2.15

Changes 2.15: 

- Additional bandwidth control values of 5 and 10 Mbps (previously the maximum was 2 Mbps) 
- Ability to ban clients based on their MAC address
- HTTP clear link error message fixed when used in web browser 
- Removed duplicate MAC address entries from status page

INSTALLATION 

None of GuestGate’s settings will be overwritten by the new firmware.      
- Uncompress the firmware file.
- Logon to GuestGate’s admin web interface
- Click on "Device Settings"
- Click on “Browse” and select the firmware file
- Click on “Install” to begin the upgrade   
- You’ll see the "Firmware is being upgraded" message.  
- Allow the process to complete. This takes several minutes.

About Gateway Firmware:

By applying this firmware, your gateway can receives fixes for various vulnerability issues, support for newly developed technologies, several authentication-related enhancements, as well as other changes.

However, due to the wide variety of gateway models, as well as the large number of manufacturers, in order to perform a firmware update properly, it would be best if you read and understand the installation steps of this specific model.

In addition to that, it is also recommend that this process be initiated in a steady power environment, and only when you have completely familiarized yourself with the upgrade procedure.

Bear in mind that failing to perform a successful update or interrupting the firmware installation in any way can cause serious malfunctions to the gateway, and might even render it unusable.

Therefore, if you intend to install this version, click the download button and apply it to the gateway. To stay up to date with new releases, all you have to do is check back with our website as often as possible.