Icom AP-90M Access Point Firmware 2.08

Improvements

- The [Rate] and [WMM Advanced] Setting screen layout has been changed.
- The firmware update fixes a problem where the wireless communication fails when the Authentication setting is [Shared Key].
- The firmware update fixes a problem that the automatic channel setting function may not work properly for [Wireless 2] (external antenna.)
- The firmware update fixes a problem that the Wireless Bridging function may not work properly when selecting 2.4GHz for Frequency Band, and selecting [Automatic] for Channel, in [Wireless 2] setting.
- The firmware update fixes a problem so that the LEDs light when an error occurs, even if the LED OFF Mode is set to “Enable” or “Enable (Completely)”.

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it’s anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don’t miss a single new release.