New features added in this release:
- Config difference CLI command: ‘diff’ from the command line will show any configuration items that are different than the default.
- ARP CLI command: ‘arpdump’ from the command line will dump the ARP table.
- (IBR6x0) Prepend System ID to GPS Sentences. System Settings -> Administration -> GPS -> Include System ID.
- (IBR6x0) Increase the maximum number of GRE tunnels from 5 to 10.
- Network Mobility (NEMO) changes to support failover. NEMO can be configured to operate with a specific WAN and will activate when a disconnection is detected from a primary WAN connection, or BGP or VRRP detect a peer failure.
Additional UI/Usability changes:
- Added a Red/Green indicator to the banner showing if the router is connected to ECM.
- For CradlePoint-based modems with supporting GPS, added ability to select between AUX and GPS ports to obtain coordinates
Defects fixed:
- NHRP with dual WAN connections does not come back up after a WAN failover
- SSH ‘cat’ command occasionally skips config portions
- Special Characters in System Identifier field can cause UDHCP to fail
- IBR600P/IBR650P only. Enabled SMS access for these devices
- Added data throttling to resolve a USB overrun situation that resulted in the router rebooting itself
- CATEGORY:
- Router / Switch / AP
- COMPATIBLE WITH:
- OS Independent
- Newer! CradlePoint MBR1200B Router Firmware 5.3.42015-02-25
- Newer! CradlePoint MBR1200B Router Firmware 5.3.02014-12-03
- Newer! CradlePoint MBR1200B Router Firmware 5.2.42014-10-24
- Newer! CradlePoint MBR1200B Router Firmware 5.2.32014-10-01
- Newer! CradlePoint MBR1200B Router Firmware 5.2.22014-08-20
- Newer! CradlePoint MBR1200B Router Firmware 5.2.02014-07-19
- CradlePoint MBR1200B Router Firmware 5.1.22014-05-13
- CradlePoint MBR1200B Router Firmware 5.1.12014-04-15
- CradlePoint MBR1200B Router Firmware 5.0.02013-11-25
- CradlePoint MBR1200B Router Firmware 4.4.22013-10-09