Cisco RV345 Router Firmware 1.0.01.16

Feature Enhancements:

- The IP Source Guard behavior is enhanced for the RV345. All of the IP/MAC entries in the user defined binding table and DHCP lease table will be protected if the IP source guard is enabled. There is no need to add entries from the DHCP lease table to IP & MAC binding table.
- Supports dual image failover mechanism
- ASD enhancements

Resolved Issues:

- SSLVPN was unable to startup when the Client Domain or the Login Banner was left blank.
- Web filter: A visit to a website was slow when the web filter rule was added.
- Router did not support EAP with tagged packet.
- IPSec VPN tunnel could not connect if setup with Wizard, and the DPD was enabled.
- RIP thru GRE function was not working.
- Content filter did not work when the Allow List was empty.
- Static DHCP entry name containing space character caused the DHCP process to fail.
- DUT executed multi processes of upgrades concurrently.
- PPPoe user name did not accept “@” and “.” in the Setup Wizard.
- GUI in Firefox browser: Page had no response when edit is used to expand category in AVC.
- RV345 LAN switch ports LED/Link sometimes worked abnormally.
- Device did not close the http connection to the webroot server when the server sent TCP FIN.
- PPPoE sometimes failed to connect.
- Fail to add web filter or app control rule with IP address group which name contains space characters.

Installation Procedure:

- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.