Release Notes:
1 WAN retry mechanism added for PCRange model.
2 Delay WLAN initialization to prevent WLAN client getting the WAN IP in EWAN mode (7300N)
3 Add support for Omatic DDNS
4 QoS refinement (same as 7800N)
5 Fixed TCP MSS.
6 Allow multiple host values separated by comma with the domain name on DDNS page
7 Add PortCtrl.asp hidden page for controlling the speed/duplex for each LAN port
8 Fixed NTP daylight saving issue in AU
9 Fixed issue whereby configuration might not be correct after system reboot.
10 Fixed WLAN IPTV issue: Adjusted the WLAN IGMP Snooping suggested by Ralink (7300N).
11 Allow the use of a hostname to access the device
12 Support added for the Sierra 503 3G card (7300GX)
Installation Procedure:
- Save the downloadable package.
- Log into the router’s web user interface.
- Navigate to the firmware upgrade section of your wireless unit.
- Select the present firmware and configure your router to install this file.
- Wait as the device carries out this process.
- Reboot the unit if required.
About Router Firmware:
Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.
Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.
In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.
If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.
If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.
If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.