NVIDIA MCX631432AS-ADAI SmartNIC Firmware 26.34.1002

Firmware which is added at the time of manufacturing, is used to run user programs on the device and can be thought of as the software that allows hardware to run. Embedded firmware is used to control the functions of various hardware devices and systems, much like a computer’s operating system (OS) controls the function of software applications. Firmware may be written into read-only memory (ROM), erasable programmable read-only memory (EPROM) or flash memory.

Important Notes:

- SR-IOV - Virtual Functions (VF) per Port - The maximum Virtual Functions (VF) per port is 127.
- It is recommended to enable the “above 4G decoding” BIOS setting for features that require large amount of PCIe resources. Such features are: SR-IOV with numerous VFs, PCIe Emulated Switch, and Large BAR Requests.
- Security Hardening Enhancements: This release contains important reliability improvements and security hardening enhancements. NVIDIA recommends upgrading your devices' firmware to this release to improve the devices’ firmware security and reliability.

Changes and New Features:

- Added LLDPEnable, LLDPTransmit and LLDPReceive properties to the RDE Port schema implementation.
- Added support for PPCC register with bulk operations, MAD for algorithm configuration and tunable parameters.
- Added support for programmable counters for PCC via PPCC register and MAD.
- Added Programmable Congestion Control (PCC) support. Note: User programmability is currently not supported.

Bug Fixes:

- Added 50 Usec delay during PML1 exit to avoid any PCIe replay timer timeout.
- Fixed an issue where set_flow_table_entry failed when aso_flow_meter action was used. 
- Enabled Multi-Host RX Rate-limiter configuration via the QEEC mlxreg and the max_shaper_rate field.
- Added "Command Unsupported" response code in cases when running the MCTP control command "Get Vendor Defined Messages Supported", and there were no supported VDMs.
- Fixed a race condition occured between the duplicate read and QP commands (2RST, 2ERR and Destroy) in the signature that caused the command to hang.
- Fixed an issue where vPort counters had wrong values.

About Network Adapter Firmware:

When connected, the operating system usually installs a generic firmware that helps the computer to recognize the newly attached device.

However, proper software must be applied if you want to make use of all features that the network adapter has available. This task also allows computers to properly recognize all device characteristics such as manufacturer, chipset, technology, and others.

Updating the adapter's firmware and utilities version might improve overall performance and stability, increase transfer speeds, fix different compatibility problems and several network-related errors, as well as bring various other changes.

To install this release, simply get the package, extract it if necessary, run the setup, and follow the instructions displayed on-screen. When done, don't forget to perform a system restart and reconnect the network adapter to make sure that all changes take effect properly.

Without further ado, if you intend to apply this version, click the download button and install the package. Moreover, check with our website as often as possible so that you don't miss a single new release.