Agere Systems' ET1011C is a Gigabit Ethernet transceiver fabricated on a single CMOS chip. Packaged in either an 128-pin TQFP, an 84-pin MLCC, or a 68-pin MLCC, the ET1011C is built on 0.13�m technology for low power consumption and application in server and desktop NIC cards. It features single power supply operation using on-chip regulator controllers. The 10/100/1000Base-T device is fully compliant with IEEE� 802.3, 802.3u, and 802.3ab standards.
The ET1011C uses an oversampling architecture to gather more signal energy from the communication channel than possible with traditional architectures. The additional signal energy or analog complexity transfers into the digital domain. The result is an analog front end that delivers robust operations, reduced cost, and lower power consumption than traditional architectures.
The ET1011C uses an oversampling architecture to gather more signal energy from the communication channel than possible with traditional architectures. The additional signal energy or analog complexity transfers into the digital domain. The result is an analog front end that delivers robust operations, reduced cost, and lower power consumption than traditional architectures.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Network Card
- COMPATIBLE WITH:
- Windows Vista
- file size:
- 3 MB
- filename:
- ET131x_drv10184.exe