MaxPower RAID eSATA 6G PCI-e 2.0 Controller Driver 1.0.13.123

Device mapping order:

The device mapping order in system is same as BIOS setting utility. The disk marked as "BOOT" will always be mapped as first SCSI disk.

INSTALLING THE DRIVER FOR A FRESH WINDOWS 7/8/2012 INSTALLATION

1. Boot from the Windows 7/8/2012 DVD.
2. When the screen "where do you want to install Windows" appears, click
"Load driver" and browse to the driver's location. The driver can be
installed from a floppy, USB flash disk, or CD/DVD.
3. Select the RocketRAID controller driver and click "Next".
4. The driver is now installed - you can now continue the Windows setup
procedure.

INSTALLING THE DRIVER FOR AN EXISTING WINDOWS 7/8/2012 SYSTEM

1. Install the adapter and power on the system. After booting the system.
2. Open the Device Manager, select the RAID controller, update driver.
3. Select "Locate and install driver software (recommended)."
4. Select "Don't Search Online."
5. Select "I don't have the disc, show me other options."
6. Select "Browse my computer for driver software.", and browse to the
location of the driver.
7. Windows should locate and install the driver. Once installed, press
"Close" to exit the Wizard. The adapter is now ready for use.

About SATA / AHCI / RAID Driver:

When you install an operating system, SATA settings (be it AHCI, RAID, or IDE mode) are detected from the BIOS. If you want to change from one mode to another after the OS has been applied, appropriate drivers are required.

Bear in mind that if you modify these settings without installing proper files first, the operating system will not be able to boot until changes are reverted or required drivers are applied.

To perform the latter task, get the package, run the available setup and follow the instructions displayed on-screen for a complete installation. Afterwards, perform a system reboot so that all changes take effect, enter BIOS menu, and set the SATA option to the mode that best describes the newly applied drivers.

So, if you intend to modify the SATA settings to the mode described by this release, click the download button, and make the desired changes. In addition to that, don’t forget to constantly check with our website so that you don’t miss a single new release.