MAXPower eSATA 6G RAID Controller Driver 1.0.10.407

Device mapping order:

The device mapping order in system is same as BIOS setting utility. The disk marked as "BOOT" will always be mapped as first SCSI disk.

Known Problems:

- Install OS to devices attached to MAXPower eSATA 6G RAID Controller
Before installing OS to devices attached to MAXPower eSATA 6G RAID Controller, you must remove the drives connected to other controllers from your system temporarily. After OS installation complete, you can put them back.
- Moving disks to other controllers
When you want to use disks previously attached to MAXPower eSATA 6G RAID
Controller on other controllers, please first delete any array information on
the disks. Otherwise your data may be lost when you want to put it back later.

About SATA / AHCI / RAID Driver:

When you install an operating system, SATA settings (be it AHCI, RAID, or IDE mode) are detected from the BIOS. If you want to change from one mode to another after the OS has been applied, appropriate drivers are required.

Bear in mind that if you modify these settings without installing proper files first, the operating system will not be able to boot until changes are reverted or required drivers are applied.

To perform the latter task, get the package, run the available setup and follow the instructions displayed on-screen for a complete installation. Afterwards, perform a system reboot so that all changes take effect, enter BIOS menu, and set the SATA option to the mode that best describes the newly applied drivers.

So, if you intend to modify the SATA settings to the mode described by this release, click the download button, and make the desired changes. In addition to that, don’t forget to constantly check with our website so that you don’t miss a single new release.