Intel RSP3DD080F RAID Adapter MegaRAID Driver 7.705.15.00

Changes:

- Disk management issue for JBOD disks

UEFI shell instructions for updating RAID Firmware:

- Download and extract all files to a USB flash drive.
- Boot the target system to EFI shell.
- Change directory to the local drive and directory containing the flash update files and the firmware image file.
- Type the name of the .nsh file matching the controller to update (e.g. "RMSP3HD080E.nsh" and press <Enter> to execute the command
- The storcli command line in the .nsh command will default to the first logical RAID contoller ("/c0"). If this there are multiple controllers, the value of controller parameter ("/Cx") will need to be modified to match the specific controller intended for update.
- Wait for the flash to complete. Do NOT reboot the system during the update.
- You can also use RAID Web Console 3 or OS version of StorCLI to update the RAID firmware. For more detail, please refer to the Intel RAID Software User's Guide.

Attention!

- Intel recommends to loading Factory Default setting after the firmware upgrade which will not affect data on any existing array.
- Reboot the system and login to the RAID BIOS Console.
- Select the controller and select 'Adapter Properties'->'Next'
- Set the 'Set Factory Defaults' setting to 'Yes' and submit the change.
- Reboot the system (the default settings are applied).
- Re-configure to the desired settings in RAID Web Console3.

Firmware downgrade notice

- Intel does not recommend to downgrade the factory installed firmware on your RAID module or controller, it has important enhancements and bug fixes you may lose when going to a previous version.
- If you need to install an older firmware version, please contact Intel for instructions on how to perform this action.

About SATA / AHCI / RAID Drivers:

When you install an operating system, SATA settings (be it AHCI, RAID, or IDE mode) are detected from the BIOS. If you want to change from one mode to another after the OS has been applied, appropriate drivers are required.

Bear in mind that if you modify these settings without installing proper files first, the operating system will not be able to boot until changes are reverted or required drivers are applied.

To perform the latter task, get the package, run the available setup and follow the instructions displayed on-screen for a complete installation. Afterwards, perform a system reboot so that all changes take effect, enter BIOS menu, and set the SATA option to the mode that best describes the newly applied drivers.

So, if you intend to modify the SATA settings to the mode described by this release, click the download button, and make the desired changes. In addition to that, don't forget to constantly check with our website so that you don't miss a single new release.