Intel ir3 2208 ROC SSD Cache Hardware RAID Firmware 23.24.0-0024

Fixes:
- Storcli is showing Read-Ahead Caching turned on by default on NytroCache VDs on new controllers and newly created NytroCache
- Cache policy of Virtual Drives(VD) does not change to Write Through(WT) mode even after detecting a bad supercap
- FW hangs when card is connected to certain bad SAS PDs
- Metadata corruption issue noticed after replacing a failed card - Source VD gets blocked
- Cache Offload firmware fails with device enquirer timeout with new NVDATA.rom
- Using power analyzer, if the power in PCI slot is made back on within 150 ms after a power failure, COL failed to complete, as the chip is getting reset while COL in progress
- OpROM not getting relocated to runtime segment if the segment address is 0xC0000
- NMR1.7-UEFi HII shows evs volume as Virtual drive instead of (Nytro Virtual Drive )
- Not possible to probe a volume > 2Tb on Niwot raid card
- NVDATA - v2.1108.06-0010
- Disable, enable, silence Alarm option is shown in MSM for the galaxy controller
- MonTask: line 280 in file ../../raid/1078int.c when set directpdmapping to ON
- WebBios displays option to locate onboard DFF
- No controller properties for Online FW Update in MegaCLi

Versions:

- Bootblock - v2.06.00.01-0000
- Common Bootblock - v07.26.05.219
- ROMENV - v1.08
- Firmware v3.360.45-2817
- Cache Offload v3.200.15-0005
- BIOS – v5.42.00
- Hii – v03.61.02
- UEFI_Driver - v0x06010300
- FCODE – v4.14.05.00
- WebBIOS – v6.5-64-e_64-Rel
- PCLI – v05.07-00

This download is valid for the products listed below:

- Intel RAID SSD Cache Controller RCS25ZB040
- Intel RAID SSD Cache Controller RCS25ZB040LX