Intel NUC10i5FNH Performance Kit RST Preinstall Driver 17.8.0.1065

INTEL RST UI/Installer:

This method is targeted for experienced users who want to have control of the configuration process are recommended to use this method.

1. Obtain the Intel RST SW/driver installation package and run the executable (SetupRST.exe)
2. Install the defaults and reboot the computer
3. From Windows desktop, find and launch the Intel RST UI application.
4. The application will open to the ‘Status’ page
5. Click the ‘Intel Optane Memory’ tab
6. Click the “Enable” link to start the enabling process.
7. A pop-up will prompt you to “Select a compatible fast drive” (the Intel Optane NVMe device)
8. Click [Yes] to start the enable process
9. Depending on the size of your Intel Optane memory module, a progress bar may be displayed
10. Let progress bar complete to 100%
11. Finalize operation
12. Click the [Reboot] button to complete the process
13. System reboots into Windows to complete the enabling process.

Platforms supported for Intel Optane Memory:

- 7th Gen or later Intel Core Processor required for Intel Optane memory support
- 8th Gen or later desktop Intel Pentium and Intel Celeron processors
- Intel 300/240 Series Chipset Family: Desktop, High End Desktop (HEDT), Workstation (WS), Intel H370 Chipset, Intel Q370 Chipset, Intel B360 Chipset, Intel C246 Chipset (WS), Intel Z370 Chipset, Intel Z390 Chipset
- Intel 200 Series Chipset Family SATA AHCI/RAID Controller - Intel Q270 Chipset, Intel Z270 Chipset, Intel H270 Chipset, Intel Q250 Chipset, Intel B250 Chipset
- 8th Generation Intel Core Processor Family Platform I/O SATA AHCI/RAID Controller Mobile Low Power (LP) - Premium-U, Base-U
- 7th generation Intel Core Processor Family Platform I/O SATA AHCI/RAID Controller- Premium U
- Intel 100 Series/C230 Series Chipset Family SATA AHCI/RAID Controller - Intel HM175 Chipset, Intel QM175 Chipset, Intel CM238 Chipset, Intel C236 Chipset 

About SATA / AHCI / RAID Preinstall Drivers:

Download this package if you intend to switch the SATA settings between available modes (AHCI, RAID, or IDE) after an operating system has been installed.

Remember that if you modify these settings without applying the proper files, the OS will not be able to boot until requirements are met or changes are reverted.

As for the installation method, it would be best if you refer to the manufacturer's update guide, read all the steps, and initiate this task only when you have completely familiarized yourself with the procedure.

Even though other platforms might also be compatible with this release, we strongly recommend that you apply the driver only on specified operating systems in order to successfully perform the installation. If a failure occurs, the computer could suffer serious malfunctions.

With these in mind, if you wish to modify the SATA settings according to the mode highlighted in this version, click the download button and make the desired changes. Visit our website as often as possible to stay up to date with the latest releases.