Intel MR 3316 ROC Hardware RAID Firmware 24.22.0-0037

Versions:

- Firmware 4.740.00-8405
- ROMENV 1.09
- BootBlock 3.10.01.00-0003
- NVDATA 4.1705.00-0008
- UEFI_Driver 0x06180203 (SIGNED)
- Hii 03.25.05.10 (SIGNED)
- FCODE 4.19.08.00
- BIOS 6.36.00.3
- CTRL-H 5.19-0603

Changes:

- Storcli shows R0 VD as WB in JBOD personality where as FW shows in WT mode
- Customer specific 3108 PCIe add-on card fails to come back while resuming from sleep state S3
- FW returns success for enabling encryption when it is failed on the drives
- Fix for proper LED blink update call for drives behind expander
- Firmware hits MonTask when it tries to PIN the cacheline in flush context during cable pull
- 9460-8i is reporting Chip Temperature of 255 when the ambient temp is about 0 C
- Ctrl-R hang after certain multiple create/remove VD operations and/or clear configurations
- Proper Error message not displayed after clean flash of boot block only after reboot

UEFI shell instructions for updating RAID Firmware:

1. Download and extract all files to a USB flash drive.
2. Boot the target system to EFI shell.
3. Change directory to the local drive and directory containing the flash update files and the firmware image file.
4. Type "update.nsh" and press <Enter> to execute the command
5. Wait for the flash to complete. Do NOT reboot the system during the update.

About SATA / AHCI / RAID Drivers:

When you install an operating system, SATA settings (be it AHCI, RAID, or IDE mode) are detected from the BIOS. If you want to change from one mode to another after the OS has been applied, appropriate drivers are required.

Bear in mind that if you modify these settings without installing proper files first, the operating system will not be able to boot until changes are reverted or required drivers are applied.

To perform the latter task, get the package, run the available setup and follow the instructions displayed on-screen for a complete installation. Afterwards, perform a system reboot so that all changes take effect, enter BIOS menu, and set the SATA option to the mode that best describes the newly applied drivers.

So, if you intend to modify the SATA settings to the mode described by this release, click the download button, and make the desired changes. In addition to that, don't forget to constantly check with our website so that you don't miss a single new release.