OCZ VeloDrive SSD LSI Driver 2.00.42 for Server 2008

Features :

The LSI_SAS2.SYS miniport driver supports these features:
- Supports End-to-End Data Protection (EEDP)
- Supports 1.5Gb, 3Gb and 6Gb SAS expanders/devices and SATA devices
- Supports PCI-Express bus protocols
- Supports LSI Fusion-MPT common software interface
- Supports multiple host adapters
- Supports multiple Logical Unit Numbers (LUNs)
- Supports Scatter-Gather
- Supports SCSI pass-through functionality
- Supports disk array configurations with no LUN 0
- Supports disk array configurations with non-contiguous LUNs
- Auto request sense
- Maximum block size support: 1 Mbyte (32-bit), 2 Mbyte (64-bit)

About SAS (Serial-Attached SCSI) Package:

Install the SAS software and your system will properly recognize the serial attached SCSI (SAS) protocol, as well as have the ability to make use of all available functions regarding this bus technology.

Once installation of this package is complete, computers will benefit from a wider range of features like error recovery, reservations, and block reclamation, but they will also be able to use functions such as tagged command queuing, and SCSI command sets, as well as several other options.

When it comes to applying this release, make sure you refer to the update guide provided by the manufacturer. As a general rule, the only steps you have to follow are: get the software, extract it if necessary, run the available setup, and follow the on-screen instructions for a complete installation.

Bear in mind that even though other OSes might be compatible, we recommend you to install this version only on specified platforms. Also, don’t forget to perform a system reboot to make sure all changes take effect properly.

That being said, download this SAS software, refer to the upgrade manual, and then apply it on your system. Visit us as often as possible and stay “updated one minute ago.”