Intel SSD 530 Series Firmware DC32/Update Tool 2.0.9

Fixes:

- This revision adds a firmware update for all of the Intel SSD 530
Series drives.

SSD 530 Series Fixes:

- Default Software Settings Preservation (SSP) for DIPM is changed from a default = on, to a DEFAULT = OFF. This addresses situations in older systems where the drive was not found after a warm reset causing blue screens. 
- Corrects an occasional miss-reporting of SMART attribute E3h (Timed Workload Read/Write ratio). 
- The drive no longer increments SMART 0Ch (Power Cycle Count) after a SECURE ERASE operation.

About SSD Toolbox:

The Solid State Drive (SSD) Toolbox is an update utility that properly recognizes the SSD unit(s) installed on your system. It also displays various pieces of information regarding the connected storage devices and searches for a new suitable firmware version.

However, before you consider downloading this version, carefully read the release notes for changes that can apply to your SSD. Once you have updated your drive, reboot to make sure that all modifications take effect.

When it comes to installing this software, the steps are very easy because all you have to do is get the downloadable package (extract it if necessary) and run the available setup. Once the installation is complete, run the Toolbox and follow the instructions for updating the SSD.

That being said, make sure this Toolbox version has a new firmware version available for your solid state drive and, if so, hit the download button, and install the software. Otherwise, check with our website as often as possible so that you don't miss the release that can improve your SSD.