How to update the firmware of your Reloop Contour controller:
1. Start Update mode of your Reloop Contour.
2. Now power OFF the Reloop device if not already done.
3. Press and Hold the “CUE” button at the bottom and power it ON.
4. Start Update Application
5. Select your Reloop Contour
6. Choose the correct firmware for your Reloop Contour in the download pool.
7. Press “Start” to start updating your Reloop device.
8. When the update was successful, you should see the following message: “Update Success!!!”
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- OS Independent
- file size:
- 21 KB
- filename:
- 223396 Firmware 13 Uni.zip