Fixes:
Please follow the steps below to upgrade the PhotoFrame firmware.
1. Format SD (Secure Digital) card
2. Copy all files from the ‘Firmware’ folder into the root folder of the SD card (The root folder is the ‘highest’ folder in hierarchy, for example F:\)
3. Make sure PhotoFrame is powered Off
4. Insert SD into PhotoFrame with the new firmware into the PhotoFrame
5. Push the Power button to power on the PhotoFrame
6. The firmware upgrade will start automatically
Please follow the steps below to upgrade the PhotoFrame firmware.
1. Format SD (Secure Digital) card
2. Copy all files from the ‘Firmware’ folder into the root folder of the SD card (The root folder is the ‘highest’ folder in hierarchy, for example F:\)
3. Make sure PhotoFrame is powered Off
4. Insert SD into PhotoFrame with the new firmware into the PhotoFrame
5. Push the Power button to power on the PhotoFrame
6. The firmware upgrade will start automatically
Warning
: Upgrade takes about 1 minute. During the upgrade do not disconnect power, remove the memory or make new connections. Otherwise this may harm your PhotoFrame.
7. When "System will reboot after replugging out of the memory card" shows, firmware upgrade has finished
8. Remove the memory card from the PhotoFrame, PhotoFrame will reboot.
9. The upgrade has completed
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- Windows XP
Windows Vista
Windows XP 64 bit
Windows Vista 64 bit
Windows 7
Windows 7 64 bit - file size:
- 1.1 MB
- filename:
- 7ff2fpa_27e_fus_aen.exe