Fixes:
- Extract all the files from the firmware zip-file to the root directory of a memory card,
- Make sure the PhotoFrame is powered off,
- Insert the memory card with the new firmware into the PhotoFrame,
- Push the Power button to power on the PhotoFrame,
- The firmware upgrade will start automatically,
During the upgrade, DO NOT remove the memory card from the PhotoFrame or make new connections to the PhotoFrame or switch of the PhotoFrame.
- The firmware upgrade can take up to 10 minutes.
- When the firmware upgrade has finished, the PhotoFrame will show the main page,
- Remove the memory card from the PhotoFrame,
- Restart the PhotoFrame,
- The upgrade has completed,
- You can check the new firmware version via Setup - Status - Firmware.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- Windows XP
Windows Vista
Windows XP 64 bit
Windows Vista 64 bit
Windows 7
Windows 7 64 bit - file size:
- 1.4 MB
- filename:
- 10ff2m4_27_fus_aen.zip