Netgear WGT624v2 Router Firmware 4.2.8

Changes:

- Fixes "108M-only" performance issue for some units.
- Fixes "wireless interference causes system reboot/lockup" issue.
- Fixes problem with 4.2.6 that caused some routers to reboot repeatedly after upgrade from 4.2.4 which required a factory default reset to get it work again 

Installation Instructions

- Before you upgrade write down all current settings as you need to enter them MANUALLY after upgrading.
- Open the browser and access the router (usually the address is http://192.168.0.1).
- Log in to the router (User Name = admin and Password = password unless you have changed it).
- Click Maintenance > Router Upgrade.
- Click Browse and locate the upgrade file (download link is below).
- Click Upload.
- Wait for the router to reboot.
- Verify that the router firmware was upgraded.
- Reset router to factory defaults.
- Wait for the router to reboot.
- Reenter the settings you noted down before upgrading. 

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn’t either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn’t be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don’t always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you’re looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don’t power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don’t miss the update that will improve your device.