Netgear WG602v3 Firmware 1.0.5

NETGEAR has been a worldwide provider of technologically advanced, branded networking products since 1996. Our mission is to be the preferred customer-driven provider of innovative networking solutions for small businesses and homes.

What's New

* Adds WPA2 functions, passing the WiFi WPA2 certification.
* Adds WMM functions, and passing the WiFi WMM certification
* Upgrades new wireless driver into 3.91.7.0

Bugs Fixed

* WPA didn�t work after ACL settings were applied.
* The wrong help message displayed �under construct�.
* Implemented Web server timeout and single user access only.
* Fix the wrong display: default gateway in IP settings always displayed as 0.0.0.0 if set device as DHCP assignment.
* If a static IP was set and applied, the Web page didn't auto switch to the new IP.
* After change password and clicking Apply, previously, you needed to input password twice.
* Passphrase input is now readable before clicking Apply.

Known Issues

* WEP Authentication type supports Auto and Shared mode only. Auto mode allows either Open System or Shared authentication type clients. Shared mode only allows Shared authentication type clients.
* ACL with WAG511v2 card can not automatically connect with an access point after being blocked.

Installation

1. Use the download link below, and save the file to a convenient location such as your desktop.
2. Double-click the file, and click Extract, saving to the same convenient location.
3. Log in to your access point.
4. Click Management > Upgrade Firmware.
5. Click Browse and select the file you extracted in Step 2.
6. Click Upgrade to start upgrading. This takes several minutes. Do NOT interrupt until the upgrade is done.