JVC KW-NT1 Car Navigation Firmware 1.3.001.0600 EU

Fixes:

- Improvement: Stabilized when receiving particular TMC message.

Firmware Update Procedure

- When the system starts up, the following screen will appear. Press [OK] to start update.
Please wait for the [OK] key to become valid since it may not work immediately after start up.
- When update is complete, the screen will show the following. Detach the front panel and remove the SD card.

About GPS Firmware:

Updating the firmware on your GPS unit can add compatibility with various devices, fix several problems (such as incorrect translations), include support for some features, route calculation algorithms, and more.

If this present release is newer than the one already applied on your GPS navigation device, you can install it by transferring the package (or its content) to the GPS through a compatible memory card or via a USB cable, and initiate the update process from the device’s setup menu.

However, please note that performing the update without knowing all the steps isn’t recommended, because, worst case scenario, you could end up with a broken device. In other words, you’re to make sure you carefully read and understand the update guide in full.

That being said, if you consider applying this release, make sure you have all the knowledge you need to perform the upgrade successfully, hit the download button, and update your GPS Navigation unit.

Check with our website as often as possible to stay be up to date with the latest releases.