- This update improves compatibility with the USB 3.0 devices, in particular issues related to the "power surge" error message
Note:
- Inside the .zip file you will find instructions for updating the firmware, one important step is that after installing the update software, you MUST reboot the PC before actually updating the firmware
- After the firmware update has been completed, please completely power down the PC. After the PC has been turned back on, if you go into the firmware utility it should now read as V9.60
- After this entire process has been completed the firmware utility can be uninstalled
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Firmware
- COMPATIBLE WITH:
- Windows XP
Windows Vista
Windows XP 64 bit
Windows Vista 64 bit
Windows 7
Windows 7 64 bit - file size:
- 1.1 MB
- filename:
- Usb3HubFWUpgrade_Setup_V0.41_VL810_0960.zip