MSI 865PEM2-ILS Bios 7.3

- Update CPU Microcode.
- Support Intel OSB Celeron D CPU.


Specifications:

CPU

￭ Supports Intel P4 Northwood/Prescott/P4 Extreme Edition processors.(PCB v1.1 only)
￭ FSB 400(Northwood only)/533/800MHz
￭ Supports up 3.2GHz and higher speed


Chipset

￭ Intel 865PE Chipset
- Supports 800/533/400MHz(Northwood only) Intel NetBurst micro-architecture bus.
- Supports AGP 8X/4X at 0.8V (AGP 3.0) or 4X at 1.5V (not support 3.3V) interface.
- Supports PC2100/PC2700/PC3200 memory.

￭ Intel ICH5 Chipset
- AC'97 2.3 interface
- 8 USB 2.0/1.1 ports
- 2 channel Ultra ATA/100 Bus Master IDE controller
- SMBus 2.0 support
- 2 serial ATA Host Controllers
- Integrated LAN controller


FSB

￭ Support 100(Northwood only)/133/200MHz
￭ Support 400(Northwood only)/533/800MHz Intel NetBurst micro-architecture bus.


Main Memory

￭ Supports two 64-bit wide DDR data channels.
￭ Available bandwidth up to 3.2GB/s(DDR 400) for single-channel mode and 6.4GB/s(DDR400)
for dual-channel mode.
￭ Supports four unbuffered DIMM of 2.5 Volt DDR SDRAM.
￭ Supports up to 4GB memory size without ECC.


Slots

￭ One AGP slot supports 8x/4x at 0.8V (AGP 3.0) or 4x at 1.5V (3.3V is not supported).
￭ Three PCI 2.2 32-bit Master PCI Bus slots.
- Supports 3.3v/5v PCI bus Interface.
￭ One CNR slot


On-Board IDE

￭ Dual Ultra DMA 66/100 IDE controllers integrated in ICH5
- Supports PIO, Bus Master operation modes.
- Can connect up to four Ultra ATA drives.

￭ Serial ATA/150 controller integrated in ICH5
- Up to 150MB/sec transfer speeds.
- Can connect up to two Serial ATA drives.


Audio

￭ AC'97 link controller integrated in ICH5
￭ 6 channels software audio codec C-Media 9739A
- Compliance with AC97 v2.2 Spec.
- Meet PC2001 audio performance requirement.
- Can support SPDIF Out via 3-pin SPDIF bracket only.


LAN

￭ Intel 82562EZ
- Integrated 10/100 Ethernet MAC and PHY in one chip.
- Supports 10Mb/s and 100Mb/s auto-negotiation operation.
- Compliant with PCI v2.2, mini PCi 1.0 and LAN on Motherboard (LOM) standard.

IEEE1394

￭ NEC PD72874


On-Board Peripherals

On-Board Peripherals include:
- 1 floppy port supports 2 FDDs with 360K, 720K, 1.2M, 1.44M and 2.88Mbytes
- 2 serial port
- 1 parallel port supports SPP/EPP/ECP mode
- 8 USB 2.0/1.1 ports (Rear x 4 / Front x 4)
- 1 Line-In/Line-Out/Mic
- 1 RJ45 connector
- 2 IEEE1394 ports (Rear x 1 / Front x 1)


BIOS

￭ The mainboard BIOS provides "Plug & Play" BIOS which detects the peripheral devices and
expansion cards of the board automatically.
￭ The mainboard provides a Desktop Management Interface(DMI) function which records your
mainboard specifications.


Dimension

￭ 24.5 cm(L) x 24.5 cm(W) Micro-ATX Form Factor

Mounting

￭ 6 mounting holes