- Fix "load previous values" function
- Fix memory TWR value setting
- Improve PCI-E compatibility
- Fix system cannot boot when setting manual CPU core
Windows Installation:
- Download the .zip file for your motherboard
- First go into your BIOS and load defaults, save and exit
- Close all open programs.
- Go into the folder where you unzipped this package and run the appropriate batch file with full administrator rights.
- For Windows XP, Vista or 7 32Bit: FPTWIN32.BAT
- For Windows XP, Vista or 7 64Bit: FPTWIN64.BAT
- Press Y in CAPITAL LETTERS to start the flash process
- DO NOT TURN OFF POWER OR RESET DURING THE FLASH PROCESS
- After the flashing is finished, the system will automatically shut down. Then power on again and go into BIOS to setup.
NOTE:
- If flash box immediately closes after flash attempt, the flash may need to be ran from a CMD prompt with administrator privileges or DOS version.
USB Flash/DOS Drive Installation:
- Create a bootable disk.
- Extract the above .zip file to your bootable disk.
- From a DOS prompt, run fptdos.bat
- Press Y in CAPITAL LETTERS to start the flash process
- DO NOT TURN OFF POWER OR RESET DURING THE FLASH PROCESS
- After the flashing is finished, shut the system down completely. Then power on again.
Important:
- After flashing verify that the correct flash was applied by checking the version number on the lower right corner of the BIOS screen.