D-Link DCS-2630L IP Camera Firmware 1.02.02

New features:

- Support CSRF protection
- Update mydlink agent to version 2.0.20-b15
- The HTTP Authentication Realm will change as “Product_Name_xx”, where xx is 2 digit suffix of MAC address. (To fix the CSRF vulnerability)
- Reduce the time of WiFi connection setup from App.
- Increasing the success rate of WPS connection setup.
- Refine RTP/RTSP.
- Enhance wireless performance.
- Add dewarp offset calibration.

Fixes:

- Check DUT CSRF protection issue, DUT web UI could be browsed with incorrect http referer and didn't need authentication.
- Firefox plug is busy easily when viewing the live streaming with 1920x1080.
- Show real MAC address in status page whatever using client mode or direct mode connection.
- DUT couldn't wireless connect to DIR-880L when DUT security mode is WPA-PSK and cipher type is TKIP/AES.
- DUT RTSP stream 2 have no audio.
- After upload signed certificate, DUT would show doesn't match with original certificate request.
- DUT motion detection trigger time is the second snapshot rather than the fourth snapshot

Installation steps:

1. Download the firmware. The file is in .bin file format.
2. Log-in camera web UI and enter setup/Maintenance/Firmware upgrade
3. Click Browse… and specify the firmware file.
4. Click Upgrade. The camera starts to upgrade and will reboot automatically when the upgrade completes. 

About Network Camera Firmware:

Updating to a newer firmware version than the one already installed on your network camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty, or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

Changing the camera’s firmware must be performed when the new release resolves an issue that your device has encountered or adds a new feature (or enhances an existing one) that could prove useful to you.

As for the installation method, the steps vary depending on the model you own, but basically, you must connect your camera via an Ethernet cable (username and password required), and use the downloadable file in the Firmware Update section to upgrade your device. Make sure you do not interrupt the installation process.

However, make sure you carefully read and understand the installation steps so that you don’t end up with a broken device. This process isn’t intended to be destructive, but still, it’s best to save all configurations before applying a different firmware.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check our website as often as possible so that you don’t miss the update that will boost your camera’s performance.