Processor
Processor type
Intel Pentium 4 Extreme Edition with HT Technology or dual-core processing
NOTE: Not all Pentium 4 processors support Hyper-Threading technology or dual-core processing.
Cache
1 MB or 2 MB
Memory
Type
533- and 667-MHz DDR2 unbuffered SDRAM
Memory connectors
four
Memory capacities
256 MB, 512 MB, 1 GB, or 2 GB non-ECC
Minimum memory
512 MB
Maximum memory
2 GB or 8 GB
NOTE: See "Addressing Memory Configurations" to verify the amount of memory available to the operating system.
BIOS address
F0000h
Computer Information
Chipset
Nvidia nForce4 SLI
DMA channels
five
Interrupt levels
24
BIOS chip (NVRAM)
4 Mb
NIC
integrated network interface capable of 10/100/1000 communication
System clock
800- or 1066-MHz data rate (depending on your processor)
Video
Type
PCI Express
Audio
Type
AC97 7.1 channel
Expansion Bus
Bus type
PCI 32-bit
PCI Express x1 and x16
Bus speed
Bus throughput
PCI: 33 MHz
PCI Express: 2.5 Gb/s raw bandwidth (bidirectional) per lane
PCI Express:
x1 slot bidirectional speed 500 MB/s
x16 slot bidirectional speed 8 GB/s
PCI
connector
three
connector size
120 pins
connector data width (maximum)
32 bits
PCI Express
NOTE: If a graphics card is installed in each of the PCI Express x16 card slots in the dual-graphics configuration, the PCI Express x1 card slot is not accessible for use.
connector
one x1
connector size
36 pins
connector data width (maximum)
1 PCI Express lane
PCI Express
connector
two x16
connector size
164 pins
connector data width (maximum)
16 PCI Express lanes
Drives
Externally accessible:
one 3.5-inch drive bays
three 5.25-inch drive bays
Available devices
Serial ATA drive, floppy drive, memory devices, CD drive, CD-RW drive, DVD drive, DVD-RW drive, and DVD and CD-RW combo drive, media card reader
Internally accessible:
three bays for 1-inch high hard drives
Connectors
External connectors:
IEEE 1394
front and back-panel 6-pin serial connectors
Network adapter
RJ45 connector
PS/2 (keyboard and mouse)
two 6-pin mini-DIN
Serial
9-pin connector
USB
two front-panel, six back-panel, and two internal USB 2.0compliant connectors
System board connectors:
IDE drive
one 40-pin connector
Serial ATA
four 7-pin connectors
Floppy drive
one 34-pin connector
Fan
four 5-pin connectors
PCI
three 120-pin connectors
PCI Express x1
one 36-pin connector
PCI Express x16
two 164-pin connectors
It is highly recommended to always use the most recent driver version available.
Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.
Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.