GitUp GIT1 Action Camera Firmware 1.20

Change log:

1. Added: Support 720P 60fps
2. Improved: Auto exposure
3. Improved: Improved audio sampling rate to 44.1KHz
4. Improved: OFF front Red LED and ON Green LED then camera fully charged
5. Improved: Disable screen backlight after 1 minute while charging but enable backlight again if user press any button
6. Fixed: Recording with 3.5mm Female Microphone Adapter
7. Changed/Fixed: Text display issues

Installation steps:

1. Prepare a micro SD card, format the SD card.
2. Download the firmware , unzip and copy the"GIT1FW.bin"file to the SD card.
3. Insert the SD card to the camera card slot.
4.Connect the camera with USB charger to start the upgrade, then the photo status green light starts blinking(the light blinking slowly at the beginning, then blinking quickly), after the light stop blinking, it means upgrade is finished. (The whole process lasts about 30 seconds)
5.After upgrade, remove the SD card and delete the firmware, otherwise it will upgrade again when you power on the camera next time. Then you can turn on the camera and switch to the setting mode to check the version of firmware.

About Action Camera Firmware:

Updating to a newer firmware version than the one already installed on your camera can improve the device’s overall performance and stability, resolve various issues, and add support for newly developed features or enhance existing ones.

On the other hand, downgrading the camera’s firmware can recover its functionality in the unlikely event the currently installed version is faulty or the device’s performance dropped after an upgrade. However, bear in mind that applying an earlier build might not always be possible.

It is recommended that changing the camera’s firmware be performed when the new release resolves an issue that your device has been encountering, or adds a new feature (or enhances an existing one) that could prove useful for you.

This process isn’t intended to be destructive, but still, it’s best to save all your personal data and configurations before applying a different firmware. Moreover, make sure that the battery is fully charged and don’t use the camera’s buttons while the installation is in progress.

When it comes to the update method, usually, you must copy the firmware file onto a compatible memory card, insert it into the camera, and browse from the menu to the device’s update section.

However, each device has various ways to enter the update mode and particular steps that should be taken for a successful upgrade, therefore make sure you read the product’s installation guide.

That being said, if you consider that this firmware improves your device in any way, then hit the download button and get the desired version; if not, check with our website as often as possible so that you don’t miss the update that will boost your camera’s performance.