Benq 5450U Scanner Driver 5.02

When you upgrade your old scanner driver to MiraScan 5.02, please notice the following details:

1) Before installing MiraScan 5.02, TURN OFF your scanner. You may turn it on only after the install process is over.
2) Following the instructions given by Install Wizard to setup MiraScan 5.02.
3) When MiraScan 5.02 has been installed, TURN ON your scanner. Enter Start Menu¡úSettings¡úControl Panel, double click
"System", select "Device Manager" tab, find your scanner in device list, and click "Refresh". If it does not work,
then select the scanner and click "Delete" button; after that, click "Refresh" again.

About Scanner Driver:

Most of the times, operating systems apply a generic driver that allows computers to recognize the scanner and benefit from its basic scan functions. If you want to make use of all available features, then appropriate software must be installed.

However, before you download this driver, check to see if the present release is compatible with your scanner model and, afterwards, make sure the package supports your computer OS version and bit architecture.

Bear in mind that even though other platforms might also be compatible, we don’t recommend you install any software on operating systems other than the highlighted ones.

If you check off all these, you should get and run the downloadable package (extract it if necessary), and follow the displayed instructions for a complete and successful installation. You should also perform a system reboot to make sure that all changes take effect properly.

That being said, click the download button, get and apply the package, and enjoy all features that the device will benefit from. Constantly check with our website to stay “updated one minute ago.”