Fixes:
- Fixed: Under the Repeater mode, the signal strength distinguish is not obviously
- Fixed: Under the Repeater mode, cannot find channel 12 and channel 13 AP
- Fixed: After login, when choose the multi-language, it should stay the original page, rather go into the Advanced mode directly.
- Fixed: Max concurrent client no. up to 32
- Change: Wireless Channel Width default setting: Auto 20/40MHz
- Change: Time Zone default setting: Get from time server > Auto
- Change: LAN IP pool starts from 192.168.1.33
- Fixed: Under the Repeater mode, the signal strength distinguish is not obviously
- Fixed: Under the Repeater mode, cannot find channel 12 and channel 13 AP
- Fixed: After login, when choose the multi-language, it should stay the original page, rather go into the Advanced mode directly.
- Fixed: Max concurrent client no. up to 32
- Change: Wireless Channel Width default setting: Auto 20/40MHz
- Change: Time Zone default setting: Get from time server > Auto
- Change: LAN IP pool starts from 192.168.1.33
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Router / Switch / AP
- COMPATIBLE WITH:
- OS Independent
- file size:
- 1.9 MB
- filename:
- NBG-418N v2_V1.00(AARP.1)C0.zip