Ubiquiti NSM3 Access Point Firmware 6.1.6.32290

New:

- New: Support for the new Wireless Network Protection feature. This feature is enabled on AP and protects the airMAX network against de-authentication attacks. airMAX AC and airMAX M client devices are supported but they must be used with an airMAX AC AP. We recommend upgrading client devices first before enabling this feature on AP.
- New: DNS settings on WAN for IPv6
- New: UNMS status icon on the top of airOS
- New: UNMS agent upgrade to v0.3.10
- airMAX-ac FF: Support for the new ReSE (Receive Signal Enhancement) feature
- airMAX-ac FF: Connection issue to AC AP when RTS threshold is ON and set to a low value
- airMAX-ac FF: Fix for PPPOE session disconnects in FF mode

Regulatory updates:

- Extended UNII-3 band up to 5725-5850 MHz for United Kingdom

Improvements:

- airMAX-ac: QOS improvements for un-encrypted PPPOE configurations
- airOS stability improvements
- airOS security improvements

Fixes:

- Fix: Speed Test reporting issues
- Fix: Maximum TX Data Rate selection (restricted to the range of MCS 2 - MCS 7 for 1x1 & 2x2 devices and MCS 10 - MCS 15 for 2x2 devices)
- Fix: Center frequencies, channel width and TX power values for AC2 agent

About Access Point Firmware:

If you update the Access Point (AP) firmware, your device can benefit from changes that fix multiple issues encountered by wireless clients, correct different user interface problems, add various functionalities, and include support for newly developed protocols.

Before performing this task, we recommend that you read and understand all the installation steps, because there are many AP models and manufacturers available. Each producer strives to make the procedure as simple as possible, but there are cases when it's anything but that.

It is also advisable that you apply a new access point firmware in a steady power environment (UPS unit will satisfy this need), using an Ethernet cable rather than a wireless connection. The latter can be easily interrupted.

With this in mind, if you wish to apply this version, click the download button and install the package on your access point. Remember to check back with our website as often as possible so that you don't miss a single new release.