Ubiquiti EdgePoint EP-R8 Router Firmware 1.10.1

Fixes:

- BGP: Fix regression in 1.10.0 when BGP "keepalive" & "holdtime" timers caused commit failure if they were less than default value.
- OSPF: Fix regression in 1.10.0 when OSPF "retransmit-interval" timer caused commit failure if it was less than 5 seconds.
- RIP: Fix regression in 1.10.0 when RIP "split-horizon" caused commit failure.
- LB: Fix regression in 1.10.0 when failover LoadBalancing did not work after reconfiguration.
- LB: Fix regression in 1.10.0 when weighted LoadBalancing did not work if 1st interface was inactive.
- System: Fix regression in 1.10.0 that caused periodic "ubnt-util" crash coredump messages in syslog
- ARP: Fix bug when "ip arp base-reachable-time" caused commit failure if VLAN interface was configured.
- Flow-Accounting: Fixed regression in 1.10.0 that caused bad accounting data to be generated by netflow if VLAN interface was configured

About Router Firmware:

Before you consider downloading this firmware, go to the system information page of the router and make sure that the currently installed version isn't either newer or matching this release.

Due to the large variety of router models and different methods for upgrading the device, it is highly recommended that you read and, above all, understand the installation steps before you apply the new firmware, even if you are a power user.

In theory, these steps shouldn't be much of a hassle for anyone, because manufacturers try to make them as easy as possible, even if they don't always succeed. Basically, you must upload the new firmware to the router through its administration page and allow it to upgrade.

If you install a new version, you can expect increased security levels, different vulnerability issues to be resolved, improved overall performance and transfer speeds, enhanced compatibility with other devices, added support for newly developed technologies, as well as several other changes.

If you're looking for certain safety measures, remember that it would be best if you perform the upload using an Ethernet cable rather than a wireless connection, which can be interrupted easily. Also, make sure you don't power off the router or use its buttons during the installation, if you wish avoid any malfunctions.

If this firmware meets your current needs, get the desired version and apply it to your router unit; if not, check with our website as often as possible so that you don't miss the update that will improve your device.