NETGEAR XSM7224 Switch Firmware 10.1.0.15
Fixes:
- Improved Fan error messages to make them easier to read.
- Added rule(order) ID to the Command {deny | permit} (IP ACL)
- Solved a condition where the switch becomes unresponsive when the copy command to a SCP destination was used.
- No longer use VLAN 2 for auto VOIP by default, custom VLAN must first be created for use by auto-VOIP
- Link between M7100-24X and GS752TXS does not come up using 1G SFP AGM731F
- [MIB]The value of dot1qVlanStaticUntaggedPorts is not correct
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Router / Switch / AP
- COMPATIBLE WITH:
- OS Independent
- file size:
- 15.1 MB
- filename:
- M7100-XSM7224_V10.1.0.15.zip
- Newer! NETGEAR XSM7224 Switch Firmware 11.0.0.242016-08-07
- Newer! NETGEAR XSM7224 Switch Firmware 11.0.0.182016-02-08
- Newer! NETGEAR XSM7224 Switch Firmware 11.0.0.142015-11-13
- Newer! NETGEAR XSM7224 Switch Firmware 11.0.0.122015-08-28
- Newer! NETGEAR XSM7224 Switch Firmware 11.0.0.112015-07-23
- NETGEAR XSM7224 Switch Firmware 10.1.0.152014-11-28