Fixes:
- Changed default wireless security to None.
- Upgraded PLC FW to MAC-QCA7420-v1.1.1-00-X-FINAL.V0406
- Fixed the specific WOL packets would be blocked by switch issue (Requested by Netgear Roberto).
- Fixed the WLAN driver would hang issue on HT40 + disable coexistence.
- Fixed the language update wouldn't be reflected on GUI issue.
- Replaced virtual_display with label in config_methods to fix Win7 zero-config would show AP-PIN issue.(Suggested by Netgear Lancelot).
- Fixed the WPS-Client IOT issue with Cisco AP.
- Added a mechanism to update a generic ART calibration data if the device was factory produced before V0.4.0.5.(Due to the previous produced device's calibration data was problematic).
- Changed default wireless security to None.
- Upgraded PLC FW to MAC-QCA7420-v1.1.1-00-X-FINAL.V0406
- Fixed the specific WOL packets would be blocked by switch issue (Requested by Netgear Roberto).
- Fixed the WLAN driver would hang issue on HT40 + disable coexistence.
- Fixed the language update wouldn't be reflected on GUI issue.
- Replaced virtual_display with label in config_methods to fix Win7 zero-config would show AP-PIN issue.(Suggested by Netgear Lancelot).
- Fixed the WPS-Client IOT issue with Cisco AP.
- Added a mechanism to update a generic ART calibration data if the device was factory produced before V0.4.0.5.(Due to the previous produced device's calibration data was problematic).
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Router / Switch / AP
- COMPATIBLE WITH:
- OS Independent
- file size:
- 4.1 MB
- filename:
- XAVN2001-V0.4.0.7.zip