NETGEAR WNR612v3 Router Firmware 1.0.0.18
Date: Feb 24, 2014
Manufacturer: NETGEAR
Fixes:
- Wire and wireless clients cannot get ip address from DUT after 28 hours in HOME_IOT test.
- GUI can't be reached when WAN is disconnected.
- Couldn't function after PPPoE connected for 1-2 mins.
- Check firmware version faild on genie in win 7 system or mac system.
- Can't modify wireless Settings success on genie in Android or ipod.
- Can't logged on by genie at very high frequency in andriod.
- Untranslated string in upgrade detect page.
- Bad performance in HOME_IOT test.
- The wireless mode default value isn't correct.
- Wire and wireless clients cannot get ip address from DUT after 28 hours in HOME_IOT test.
- GUI can't be reached when WAN is disconnected.
- Couldn't function after PPPoE connected for 1-2 mins.
- Check firmware version faild on genie in win 7 system or mac system.
- Can't modify wireless Settings success on genie in Android or ipod.
- Can't logged on by genie at very high frequency in andriod.
- Untranslated string in upgrade detect page.
- Bad performance in HOME_IOT test.
- The wireless mode default value isn't correct.
It is highly recommended to always use the most recent driver version available.
Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer.
- CATEGORY:
- Router / Switch / AP
- COMPATIBLE WITH:
- OS Independent
- file size:
- 3.5 MB
- filename:
- wnr612v3_wnr500-V1.0.0.18.zip